How to Use Trekking Poles Uphill and Downhill (and on Traverses)

⏱️ Estimated reading time: 14 min

Short answerShorten your poles by about 10 to 15 cm for long climbs and plant them ahead of you; lengthen them by the same for long descents and plant them below you. On a traverse, set the uphill pole shorter. Plant both poles on big steps, widen your stance on scree and free your hands from the straps on rough ground.
Hillwalker seen from behind descending a stone-pitched fell path with two trekking poles, autumn bracken and a lake in the valley below
On this page: Overview
    Summarize with AI

    Key Takeaways

    Yes, on a long climb. Ordnance Survey suggests shortening them by about 10 to 15 cm from your flat-ground length, so you can plant the tips ahead of you on the slope and push as you step up. On short rises, leave the length alone and simply plant the poles a little further forward.

    Lengthen them by about 10 to 15 cm for a long descent, plant both tips below you on the next step or a little ahead of your feet, and step down onto the ground between them. Keep your weight over your feet rather than leaning back, take shorter steps and let the poles add balance and control.

    On a path that cuts across a slope, shorten the uphill pole and lengthen the downhill one, so both hands stay at about the same height. If you do not want to change the lengths for a short traverse, hold the uphill pole lower down the shaft and keep the downhill pole at its normal grip.

    Yes, but stop to do it rather than adjusting as you walk. Bollsen’s folding models adjust between 115 and 135 cm, which leaves room to lengthen for a descent but may not let shorter walkers shorten them much for a climb. The telescopic Alpine Explorer has the wider range, from 95 to 135 cm.

    On an easy, grassy descent the straps can stay on. On steep, rocky or stepped ground, many walkers take their hands out and rest their palms on top of the grips, as Ordnance Survey describes, so they can let go of a pole quickly if it catches between rocks.

    On a flat path, poles are mostly about rhythm. The moment the path tilts, they start doing a different job. Going up, they give you something to push against. Going down, they give you two extra points of contact while you pick your footing. On a path that slants across a hillside, they help you stay level when one foot is higher than the other.

    Each of those situations works better with a slightly different set-up. This guide covers climbs, descents, traverses, steep steps and loose ground, with a quick reference table you can come back to. If you are new to poles, start with our guide on how to use trekking poles on flat paths, and if you have not chosen a pair yet, read how to choose trekking poles first.

    Start with the right flat-ground length

    Every change on a gradient starts from your normal setting. Stand on level ground in your walking boots, hold the grip with the tip beside your foot, and check that your elbow is bent at about 90°. Ordnance Survey’s guide to hiking poles uses the same right-angle test. Note the number on the shaft at that length, because you will come back to it on every flat stretch.

    If you are not sure where your starting point should be, our guide on what length your poles should be has a height chart and a step-by-step check.

    How much to change the length for climbs and descents

    Ordnance Survey’s advice is simple: on uphill slopes, shorten your poles by about 10 to 15 cm so you can plant them uphill and use them to support your step. On downhill slopes, lengthen them by about 10 to 15 cm so you can plant them ahead of your feet without leaning forwards.

    Treat those figures as a starting range, not a fixed rule. A gentle path needs less change than a steep one, and you will soon learn what feels right on your local hills. Two habits make it easier:

    • Only adjust for long gradients. On a short rise or dip, keep the length and change where you plant the tips. Stopping every few minutes to fiddle with the poles breaks your rhythm more than a slightly wrong length does.
    • Change both poles by the same amount. Use the scale markings on the shaft, if your poles have them, so the two match, then lock each section fully and test it with your weight before you set off again.

    This is where the type of pole matters. The telescopic Alpine Explorer (95–135 cm) has a 40 cm adjustment range, so most walkers from 1.40 m upwards can shorten it for a climb and lengthen it for a descent from the same starting point. The two folding models, the Expedition Pro and the 3K Carbon Extreme+, adjust from 115 to 135 cm for walkers from 1.60 m to 2 m. That range covers lengthening for most descents, but if your flat setting is already near 115 cm, there is little room left to shorten for a climb. In that case, hold the pole a little lower down for steep sections instead. Our comparison of folding vs telescopic poles covers the other trade-offs.

    Going uphill

    On a climb, the poles go in front of you rather than beside you. Ordnance Survey describes planting them further ahead so you can push up and lift your other foot. The basic opposite arm, opposite leg rhythm stays the same; only the plant moves forward.

    1. Shorten both poles for a long climb.
    2. Keep your hands through the straps, threaded from below, so you can push through the strap without gripping hard.
    3. Plant each tip a little ahead of your leading foot, on firm ground.
    4. Push down and back through the pole as you step up, then bring it forward with the next step.
    5. Take shorter steps and settle into a pace you can hold. A steady rhythm on a long climb beats bursts of speed and frequent stops.

    On very steep ground, some walkers switch to planting both poles together and then stepping up between them. It is slower, but it can feel steadier on a slope where the single-pole rhythm keeps slipping.

    Going downhill

    On a descent, the poles go below you. The British Mountaineering Council describes resting your hands on top of the grips, placing the poles below the step, transferring some of your weight onto them and stepping down lightly. That gives you two extra points of contact while your feet find the next placement.

    1. Lengthen both poles for a long descent.
    2. Plant the tips a little ahead of your feet or on the step below.
    3. Step down between or just behind the poles, keeping your weight over your feet rather than leaning back into the slope.
    4. Bend your legs slightly and keep your steps short. Short steps give you more control than long strides on a steep path.
    5. Look two or three steps ahead, so you can choose where the poles and your feet will go next.

    On long descents, such as the way down from Ben Nevis or Scafell Pike, the temptation is to speed up once the end is in sight. That is usually when footing gets careless. Keep the same steady rhythm all the way to the valley floor. If you are planning a whole day of big descents, our guide to poles on the Three Peaks covers the route in more detail.

    Traverses: one pole shorter, one longer

    A traverse is any path that cuts across a slope, so the ground is higher on one side than the other. With both poles at the same length, the uphill pole pushes your hand up towards your shoulder and the downhill pole leaves you reaching.

    For a long traverse, shorten the uphill pole and lengthen the downhill one until both hands sit at about the same height. When the path turns and the slope switches sides, swap the settings over. For a short traverse, skip the adjustment: hold the uphill pole lower down the shaft and keep the downhill pole at its normal grip.

    Plant the downhill pole slightly below the path edge only where the ground is firm. On a narrow path with a steep drop, it is often better to keep both poles on the path itself.

    Steep steps and stone-pitched paths

    Many popular fell paths in the Lake District are stone-pitched: large, locally sourced stones set flat side up into the ground to form small, irregular steps, and you will meet similar paths on other UK hills. Fix the Fells, which repairs these paths, explains that when walkers step off a worn path onto its edges, the erosion gets worse. So stay on the stones and plant your poles on them too.

    For big steps, the BMC suggests two techniques. Going up short, rocky steps, keep both poles slightly behind you and push down on them as you make the step. Going down, place both poles below the step, put some of your weight on them and step down lightly. Planting both poles together on a big step is often called a double plant, and it gives you a steadier base than one pole at a time.

    Wet pitched stone can be slippery, and so can a metal tip on smooth rock. Aim the tips for the gaps between stones or the rougher edges. Our guide on which tips and baskets to use explains when a walking cap or a bare tip suits the ground better.

    Scree and loose ground

    Scree is loose, broken rock on a slope, and it moves under your feet and your poles. A few changes help:

    • Widen your base. Plant the poles a little further out to the sides than on a path, so you have a broader stance.
    • Test before you trust. Press a pole into the scree before you put weight on it. If the stones slide, move the tip.
    • Hands out of the straps. On loose rock, a tip can wedge between stones. With your hands free, you can let go rather than being pulled off balance.
    • Short steps, steady pace. Move one pole or foot at a time and keep your weight over your feet.

    If a scree slope looks steep or the run-out below is a drop, poles are not the answer. Look for a better line or turn back.

    Quick reference: poles on gradients

    How to set and plant trekking poles on climbs, descents, traverses and steps
    GradientLength changeWhere to plantStraps
    Long climbShorter, about 10 to 15 cm (Ordnance Survey)A little ahead of your leading foot; push as you step upOn, hands threaded from below
    Long descentLonger, about 10 to 15 cm (Ordnance Survey)Below you, a little ahead of your feet or on the next stepOn for easy ground; off on steep or rocky ground, palms on top of the grips
    TraverseUphill pole shorter, downhill pole longerBoth on the path; downhill pole below the edge only on firm groundOn for easy ground; off where the path is narrow or rocky
    Steep stepsKeep your current settingGoing up: both poles slightly behind you. Going down: both poles on the step belowOff, so you can use your hands
    Scree or loose groundKeep your current settingWider than usual; test each plant before you weight itOff
    Short rise or dipNo changeFurther forward going up, closer to your feet going downOn

    Straps on climbs and descents

    Uphill, the strap earns its keep. Thread your hand up through the loop from below and close your fingers over the strap and grip together. You can then push through the strap and keep a relaxed hand on a long climb.

    Downhill is different. On an easy grass or track descent, keeping the straps on is fine. On steep, rocky or stepped ground, Ordnance Survey suggests taking your hands out of the straps and placing them on top of the poles. With your hands free, a pole that catches between two rocks simply stays behind, rather than pulling you off balance. We go into fitting and adjustment in more depth in our guide on how to use pole straps.

    Snow on the hill

    Old snow can linger on high, north-facing slopes into late spring, especially in Scotland. Mountaineering Scotland advises walkers without an ice axe and crampons to choose a snow-free alternative or turn round when a route crosses hard snow patches. Poles help with balance on soft snow, but they are no substitute for winter kit on hard or icy ground. The Expedition Pro and the 3K Carbon Extreme+ come with a snow plate in the box for soft snow.

    Practise before the big day

    Find a local hill with a mix of steps and grass and try each technique on it before a long walk. Adjust the length for the climb, change it again at the top, try a short traverse, and walk down a few steps with a double plant. Ten minutes is enough to make the changes feel automatic, so you are not working them out on a wet descent at the end of the day.

    Poles are a help with balance, footing and pace, not a fix for every slope. If you have a joint condition or are coming back to hill walking after a long break, ask your GP or a physiotherapist how best to build up to steep ground.

    Every Bollsen pole comes with a 40-day money-back guarantee, so you have time to try the length changes on your own hills.

    One thought on “How to Use Trekking Poles Uphill and Downhill (and on Traverses)”

    1. Pingback: Do You Need Walking Poles for the Three Peaks? | BOLLSEN

    Comments are closed.